Analysis of the Heat Transfer Performance of Nanofluids in Micro-Cylinder Groups

  • Lina Wafaa Belhadj Senini Laboratoire des Sciences et Ingénierie Maritimes, Faculté de Génie Mécanique, Université des Sciences et de la Technologie d'Oran Mohammed Boudiaf, Oran, Algérie
  • Mustpaha Boussoufi Laboratoire des Sciences et Ingénierie Maritimes, Faculté de Génie Mécanique, Université des Sciences et de la Technologie d'Oran Mohammed Boudiaf, Oran, Algérie
  • Amina Sabeur Laboratoire des Sciences et Ingénierie Maritimes, Faculté de Génie Mécanique, Université des Sciences et de la Technologie d'Oran Mohammed Boudiaf, Oran, Algérie https://orcid.org/0000-0001-6972-4136
Keywords: Nanoparticles, Micro-cylinder-group, Heat transfer enhancement, Convection, Laminar regime

Abstract

The objective of this study is to investigate, through numerical simulations, the flow and heat transfer characteristics of Al2O3, Cu, TiO2, and SiC water-based nanofluids flowing over micro-cylinder groups arranged in an inline configuration. The simulations were carried out under laminar flow conditions, and the analysis considered seven different low values of the Reynolds number, with a constant volume fraction of 2%. The aim of this investigation was to determine how nanofluids, i.e., suspensions of nanoparticles in water as the base fluid, can affect the pressure drop and heat transfer performance in micro-cylinder groups. To accomplish this, the finite volume method was employed to evaluate the impact of the nanofluids on pressure drop and heat transfer characteristics in the micro-cylinder groups. The study results demonstrate that, for all the nanofluids studied, the pressure drop and friction factor of the micro-cylinder groups increased with increasing Reynolds number. This behavior can be attributed to the interaction between the nanoparticles and the wall, which results in an increase in friction. Furthermore, the Nusselt number was found to increase with increasing Reynolds number. The SiC/Water nanofluid exhibited the highest Nusselt numbers among the four nanofluids tested, indicating that it provides better heat transfer performance than the other nanofluids. These results are consistent with experimental findings, indicating that the numerical simulations were accurate and reliable.

Downloads

Download data is not yet available.

References

D.B. Tuckerman, and R.F.W. Pease, “High Performance Heat Sinking for VLSI,” IEEE Electron Device Letters, 2(5), 126-129 (1981). https://doi.org/10.1109/EDL.1981.25367

H. Mizunuma, M. Behnia, and W. Nakayama, “Heat transfer from micro-finned surfaces to flow of fluorine coolant in reduced-size channels,” IEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A, 20(2), 138–145 (1997). https://doi.org/10.1109/95.588565

A. Koşar, C. Mishra, and Y. Peles, “Laminar flow across a bank of low aspect ratio micro pin fins,” J. Fluids Eng. 127, 419–430 (2005). https://doi.org/10.1115/1.1900139

E. Galvis, B.A. Jubran, F.Xi.K. Behdinan, and Z. Fawaz, “Numerical modeling of pin-fin micro heat exchangers,” Heat Mass Transfer, 44, 659–666 (2008). https://doi.org/10.1007/s00231-007-0291-2

M. Ohadi, J. Qi, and J. Lawler, “Ultra-Thin Film Evaporation (UTF) – Application to Emerging Technologies in Cooling of Microelectronics,” in: Microscale Heat Transfer Fundamentals and Applications. NATO Science Series II: Mathematics, Physics and Chemistry, vol. 193, edited by S. Kakaç, L. Vasiliev, Y. Bayazitoğlu, and Y. Yener (Springer, Dordrecht, 2005). pp. 321–338. https://doi.org/10.1007/1-4020-3361-3_17

N. Guan, Z.G. Liu, and C.W. Zhang, “Numerical investigation on heat transfer of liquid flow at low Reynolds number in micro-cylinder-groups,” Heat Mass Transfer, 48, 1141–1153 (2012). https://doi.org/10.1007/s00231-011-0956-8

N. Guan, and Z.G. Liu, “Numerical investigation of laminar flow and heat transfer in micro-cylinder-groups,” in: Proceedings of the 8th International Conference on Nanochannels, Microchannels and Mini channels, (ASME, Montreal, Canada, 2010) pp. 645–654. https://doi.org/10.1115/FEDSM-ICNMM2010-30423

S.U.S. Choi, and J A. Eastman, “Enhancing thermal conductivity of fluids with nanoparticles,” in: ACME International Mechanical Engineering Congress & Exposition (San Francisco, Ca, 1995). https://www.osti.gov/servlets/purl/196525

E. Abu-Nada, Z. Masoud, and A. Hijazi, “Natural convection heat transfer enhancement in horizontal concentric annuli using nano-fluids,” International Communications in Heat and Mass Transfer, 35, 657–665 (2008). https://doi.org/10.1016/j.icheatmasstransfer.2007.11.004

H.A. Mohammed, P. Gunnasegaran, and N.H. Shuaib, “Heat transfer in rectangular micro-channels heat sink using nano-fluids,” International Communications in Heat and Mass Transfer, 37, 1496–1503 (2010). https://doi.org/10.1016/j.icheatmasstransfer.2010.08.020

M. Akbari, N. Galanis, and A. Behzadmehr, “Comparative assessment of single and two-phase models for numerical studies of nano-fluid turbulent forced convection,” International Journal of Heat and Fluid Flow, 37, 136–146 (2012). https://doi.org/10.1016/j.ijheatfluidflow.2012.05.005

M.K. Moraveji, R.M. Ardehali, and A. Ijam, “CFD investigation of nano-fluid effects (cooling performance and pressure drop) in mini-channel heat sink,” International Communications in Heat and Mass Transfer, 40, 58–66 (2013). https://doi.org/10.1016/j.icheatmasstransfer.2012.10.021

A. Adriana, “Simulation of Nano-fluids Turbulent Forced Convection at High Reynolds Number: A Comparison Study of Thermophysical Properties Influence on Heat Transfer Enhancement,” Flow Turbulence Combust, 94, 555–575 (2015) https://doi.org/10.1007/s10494-014-9590-0

Z. Said, M.A. Sabiha, R. Saidur, A. Hepbasli, N.A. Rahim, S. Mekhilef, and T.A. Ward, “Performance enhancement of a Flat Plate Solar collector using Titanium dioxide nano-fluid and Polyethylene Glycol dispersant,” Journal of Cleaner Production, 92, 343-353 (2015). https://doi.org/10.1016/j.jclepro.2015.01.007

A. Bouhezza, S. Boubeggar, and K. Boukerma, “Simulation numérique du transfert de chaleur de nano-fluide dans un canal,” in: Third International Conference on Energy, Materials, Applied Energetics and Pollution, (Constantine, Algeria, 2016). pp. 302 307. https://www.umc.edu.dz/images/50-BOUHEZZA.pdf

E. Dabiri, F. Bahrami, and S.M. Zadeh, “Experimental investigation on turbulent convection heat transfer of SiC/W and MgO/W nanofluids in a circular tube under constant heat flux boundary condition,” J. Therm. Anal. Calorim. 131, 2243–2259 (2018). http://dx.doi.org/10.1007/s10973-017-6791-5

J. Bowers, H. Cao, and G. Qiao, “Flow and heat transfer behavior of nano-fluids in micro-channels,” Prog. Nat. Sci.: Mater. Int. 28, 225–234 (2018). https://doi.org/10.1016/j.pnsc.2018.03.005

H. Goodarzi, O.A. Akbari, M.M. Sarafraz, M. Mokhtari, M.R. Safaei, and G.A.S. Shabani, “Numerical Simulation of Natural Convection Heat Transfer of Nanofluid with Cu, MWCNT And Al2O3 Nanoparticles in A Cavity with Different Aspect Ratios,” Journal of Thermal Science and Engineering Application, 11(6), 061020 (2019). https://doi.org/10.1115/1.4043809

X. Zhang, G. Meng, and Z. Wang, “Experimental study on flow and heat transfer characteristics of SiC-water Nanofluids in micro-cylinder-groups,” International Journal of Heat and Mass Transfer, 147, 118971 (2020). https://doi.org/10.1016/j.ijheatmasstransfer.2019.118971

S. Karimi, M.M. Heyhat, A.H.M. Isfahani, and A. Hosseinian, “Experimental investigation of convective heat transfer and pressure drop of SiC/water nanofluid in a shell and tube heat exchanger,” Heat and Mass Transfer 56, 2325–2331 (2020). https://link.springer.com/article/10.1007/s00231-020-02844-7

D. Zheng, J. Wang, Z. Chen, J. Baleta, and B. Sundén, “Performance analysis of a plate heat exchanger using various nanofluids,” International Journal of Heat and Mass Transfer, 158, 119993 (2020). https://doi.org/10.1016/j.ijheatmasstransfer.2020.119993

S. Ahmad, S. Abdullah, and K. Sopian, “Numerical and Experimental Analysis Of The Thermal Performances of Si'/Water and Al2O3/Water Nanofluid Inside A Circular Tube with Constant-Increased-PR Twisted Tape,” Energies, 13, 2095 (2020). https://doi.org/10.3390/en13082095

B.C. Pak, and Y.I. Cho, “Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles,” Exp. Heat Transf. 11, 151-170 (1998). https://doi.org/10.1080/08916159808946559

S.E.B. Maiga, C.T. Nguyen, N. Galanis, and G. Roy, “Heat transfer behaviours of nanofluids in a uniformly heated tube,” Superlattices Microstruct. 35, 543-557 (2004). https://doi.org/10.1016/j.spmi.2003.09.012

V. Bianco, F. Chiacchio, O. Manca, and S. Nardini, “Numerical investigation of nanofluids forced convection in circular tubes,” Appl. Therm. Eng. 29, 3632-3642 (2009). https://doi.org/10.1016/j.applthermaleng.2009.06.019

H.C. Brinkman, “The viscosity of concentrated suspensions and solution,” J. Chem. Phys. 20, 571–581 (1952). https://doi.org/10.1063/1.1700493

J.C. Maxwell, A Treatise on Electricity and Magnetism, (Clarendon Press, 1881).

G.A. Slack, “Thermal Conductivity of MgO, Al2O3, MgAl2O4, and Fe3O4 Crystals from 3 to 300 K,” Phys. Rev. 126, 427 (1962). https://doi.org/10.1103/PhysRev.126.427

H. Kim, S.R. Choi, and D. Kim, “Thermal conductivity of metal-oxide nanofluids: particle size dependence and effect of laser irradiation,” J. Heat Transf. 129, 298-307 (2007). https://doi.org/10.1115/1.2427071

International Atomic Energy Agency, Vienna International Centre, PO Box 100, A-1400 Vienna, Austria, Thermo-physical properties of materials for nuclear engineering: a tutorial and collection of data. (2008). https://www-pub.iaea.org/MTCD/Publications/PDF/IAEA-THPH_web.pdf

D.W. Green, and R.H. Perry, Perry’s Chemical Engineers’ Handbook, (McGraw-Hill Professional, 1999).

Published
2023-12-02
Cited
How to Cite
Senini, L. W. B., Boussoufi, M., & Sabeur, A. (2023). Analysis of the Heat Transfer Performance of Nanofluids in Micro-Cylinder Groups. East European Journal of Physics, (4), 109-119. https://doi.org/10.26565/2312-4334-2023-4-11