The CZTS Thin Films Grown by Sulfurization of Electrodeposited Metallic Precursors: The Effect of Increasing Tin Content of the Metallic Precursors on the Structure, Morphology and Optical Properties of the Thin Films
Abstract
A study has been carried out to investigate the influence of the amount of Sn in the precursor solution, on some physical properties of CZTS films grown by sulfurization of electrodeposited metallic precursors. The growth of the CZTS samples was achieved by sequential electrodepositon of constituent metallic layers on ITO glass substrates using a 3-electrode electrochemical cell with graphite as a counter electrode and Ag/AgCl as the reference electrode. The Sn-content in the metallic precursor was varied by varying the deposition time of Sn. The stacked elemental layer was then soft annealed in Argon at 350 °C, and subsequently sulfurized at 550° C to grow the CZTS thin films. The structure, morphology and optical properties were investigated. X-ray diffraction studies revealed that, irrespective of the Sn content all the films were polycrystalline and exhibited the Kesterite CZTS structure with preferred orientation along the (112) plane. However, there was an increase in the amount of peaks indexed to the undesirable secondary phases, as the Sn content in metallic precursor was increased. Optical absorption measurements revealed the existence of a direct transition with band gap values decreasing from 1.74 eV to 1.25 eV with increasing amounts of Sn. The lower value for the band gap was attributed to the presence of secondary phases formed in addition to the CZTS film. Morphology of the sulfurized films showed a compact and rocky texture with good coverage across the entire substrate. However, CZTS films with a higher Sn content appeared to have a molten metallic surface with deep cracks which could have adverse effects on the electrical properties of the film. EDAX analysis showed all the films were consistent with the formation of CZTS. It is evident from all the characterization techniques that increasing the Sn content of the stacked metallic precursors beyond stoichiometric amounts had an adverse effect on the structural and optical properties of CZTS films grown by this technique.
Downloads
References
S.D. Sharma, K. Bayikadi, S. Raman, and S. Neeleshwar, Nanotechnology, 31, (36), 365402 (2020). https://doi.org/10.1088/1361-6528/ab9393
S. Prabhu, S.K. Pandey, and S. Chakrabarti, International Journal of Energy Research, 46(11), 15300 (2022). https://doi.org/10.1002/er.8232
K. Diwate, K. Mohite, M. Shinde, S. Rondiya, A. Pawbake, A. Date, H. Pathan, and S. Jadkar, Energy Procedia, 110, 180 (2017). https://doi.org/10.1016/j.egypro.2017.03.125
D.B. Mitzi, O. Gunawan, T.K. Todorov, K. Wang, and S. Guha, Solar Energy Materials and Solar Cells, 95(6), 1421 (2011). https://doi.org/10.1016/j.solmat.2010.11.028
S. Giraldo, Z. Jehl, M. Placidi, V. Izquierdo-Roca, A. Pérez-Rodríguez, and E. Saucedo, Advanced Materials, 32, 1806692 (2019). https://doi.org/10.1002/adma.201806692
C. Gougaud, D. Rai, S. Delbos, E. Chassaing, and D. Lincot, Journal of The Electrochemical Society, 160(10), 485 (2013). https://doi.org/10.1149/2.105310jes
I. Nkrumah, F.K. Ampong, A. Britwum, M. Paal, B. Kwakye-Awuah, R.K. Nkum, and F. Boakye, Chalcogenide Letters, 20(3), 205 (2023). https://doi.org/10.15251/CL.2023.203.205
S. Thanikaikarasan, T. Mahalingam, T. Ahamad, S. M. Alshehr, Journal of Saudi Chemical Society, 24, 955 (2020). https://doi.org/10.1016/j.jscs.2020.10.003
N. Jahan, R. Matin, M.S. Bashar, M. Sultana, M. Rahaman, M.A. Gafur, M.A. Hakim, et al., Am. Int. J. Res. Sci. Technol. Eng. Math, 1, 69 (2016). http://iasir.net/AIJRSTEMpapers/AIJRSTEM16-141.pdf
A. Weber, R. Mainz, and H.W. Schock, Journal of Applied Physics, 107(1), 013516 (2010). https://doi.org/10.1063/1.3273495
H. Borate, A. Bhorde, A. Waghmare, S. Nair, P. Subhash, A. Punde, P. Shinde, et al., ES Materials & Manufacturing, 11, 30 (2020). http://dx.doi.org/10.30919/esmm5f934
S. Mahjoubi, N. Bitri, M. Abaab, and I. Ly, Materials Letters, 216, 154 (2018). https://doi.org/10.1016/j.matlet.2018.01.004
D. Payno, S. Kazim, M. Salado, and S. Ahmad, Solar Energy, 224, 1136 (2021). https://doi.org/10.1016/j.solener.2021.06.038
H. Zhang, M. Xie, S. Zhang, and Y. Xiang, Journal of Alloys and Compounds, 602, 199 (2014). http://dx.doi.org/10.1016/j.jallcom.2014.03.014
S. Siebentritt, and S. Schorr, Progress in Photovoltaics: Research and Applications, 20(5), 512 (2012). https://doi.org/10.1002/pip.2156
G. Larramona, S. Levcenko, S. Bourdais, A. Jacob, C. Choné, B. Delatouche, C. Moisan, et al., Advanced Energy Materials, 5(24), 1501404 (2015). https://doi.org/10.1002/aenm.201501404
E.A. Botchway, F.K. Ampong, I. Nkrumah, R.K. Nkum, and F. Boakye, Open Journal of Applied Sciences, 9(9), 725 (2019). https://doi.org/10.4236/ojapps.2019.99059
J.J. Scragg, T. Ericson, T. Kubart, M. Edoff, and C. Platzer-Bjorkman, Chemistry of Materials, 23(20), 4625 (2011). https://doi.org/10.1021/cm202379s
S. Chen, J. Tao, H. Tao, Y. Shen, L. Zhu, J. Jiang, X. Zeng, and T. Wang, Materials Technology, 30(5), 306 (2015). https://doi.org/10.1179/1753555715Y.0000000007
X. He, H. Shen, J. Pi, C. Zhang, and Y. Hao, Journal of Materials Science: Materials in Electronics, 24(11), 4578 (2013). https://doi.org/10.1007/s10854-013-1445-2
T. Hreid, Doctoral dissertation, Queensland University of Technology, 2016.
F. Jiang, S. Ikeda, Z. Tang, T. Minemoto, W. Septina, T. Harada, and M. Matsumura, Research and Applications, 23(12), 1884 (2015). https://doi.org/10.1002/pip.2638
S. Mondal, S.R. Bhattacharyya, and P. Mitra, Bulletin of Materials Science, 36, 223 (2013). https://doi.org/10.1007/s12034-013-0462-3
D.B. Puzer, I. Nkrumah, F.K. Ampong, M. Paal, E.A. Botchway, R.K. Nkum, F. Boakye, Chalcogenide Letters, 18(8), 481 (2021). https://chalcogen.ro/481_PuzerDB.pdf
J.J. Scragg, P.J. Dale, L.M. Peter, G. Zoppi, and I. Forbes, Physica Status Solidi B, 245(9), 1772 (2008). https://doi.org/10.1002/pssb.200879539
O.V. Goncharova, and V.F. Gremenok, Semiconductors, 43, 96 (2009). https://doi.org/10.1134/S1063782609010199
M. Paal, I. Nkrumah, F.K. Ampong, D.U. Ngbiche, R.K. Nkum, and F. Boakye, Science Journal of University of Zakho, 8(3), 97 (2020). https://doi.org/10.25271/sjuoz.2020.8.3.752
C.K. Bandoh, I. Nkrumah, F.K. Ampong, R.K. Nkum, and F. Boakye, Chalcogenide Letters, 18(2), 81 (2021). https://chalcogen.ro/81_BandohCK.pdf
M. Khammar, F. Ynineb, S. Guitouni, Y. Bouznit, and N. Attaf, Applied Physics A, 126(6), 398 (2020). https://doi.org/10.1007/s00339-020-03591-6
Copyright (c) 2023 E.A. Botchway, Francis Kofi Ampong, Isaac Nkrumah, D.B. Puzer, Robert Kwame Nkum, Francis Boakye
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
