Numerical Investigation of Lead-Free Perovskite Solar Cells Based on FASnI₃/ZrS₂ Structure Using SCAPS-1D Simulator
DOI:
https://doi.org/10.26565/2312-4334-2025-4-26Keywords:
FASnI₃, ZrS₂, SCAPS-1D, Lead-free perovskite solar cells, Electron transport layer, Photovoltaic modeling, Solar energyAbstract
This study presents a numerical investigation and optimization of lead-free perovskite solar cells using SCAPS-1D simulation. The proposed device is composed of formamidinium tin iodide (FASnI3, absorptive layer), zirconium disulfide (ZrS2, electron transport material), gold (Au, the back contact), and Fluorine-doped tin oxide (SnO2:F, the front contact).The effects of varying the thickness, defect density, doping concentration, operating temperature, and back-contact work function on the photovoltaic performance were studied to determine the optimal device architecture with the highest power conversion efficiency (PCE). Results reveal that the initial performance of FASnI₃/ZrS₂ solar cells was as follows: open-circuit voltage (VOC) =0.99V, short-circuit current (JSC) = 20.7mA/cm2, Fill factor (FF) = 60.13%, and power conversion efficiency (PCE)=12.4%.After optimization, the performance of FASnI₃/ZrS₂ significantly improved, achieving a PCE of 23.3%, FF of 82.4%, and JSC of 30.2mA/cm².This remarkable improvement in these parameters is attributed to the increase in thickness and doping density of the FASnI₃ and ZrS₂ layers which lead to improved light absorption and charge generation. Additionally, the 5.3 eV work-function of the back contact was found to create a better energy level alignment with the FASnI₃ layer, which facilitates charge extraction. These findings offer valuable insights into the design of efficient, stable, and lead-free perovskite solar cells.
References
J. Zhang, Geosci. Front. 15(5), 101873 (2024). https://doi.org/10.1016/j.gsf.2024.101873
M.S. Reza, A. Ghosh, N. Drissi, H. Al-Dmour, R.K. Prodhan, M.M. Islam, S. Begum, et al., RSC Adv. 14, 36675 (2024). https://doi.org/10.1039/D4R07912D
A.S. Abdulkarim, M. Srivastava, T. Ngulezhu, D. Singh, K. Strzałkowski, R.C. Singh, M.Z.A. Yahya, et al., Curr. Appl. Phys. 71, 190 (2025). https://doi.org/10.1016/j.cap.2024.12.025
A. Kojima, K. Teshima, Y. Shirai, and T. Miyasaka, J. Am. Chem. Soc. 131(17), 6050 (2009). https://doi.org/10.1021/ja809598r
M. Tarekuzzaman, N. Shahadat, M. Montasir, O. Alsalmi, M.H. Mia, H. Al-Dmour, M. Rasheduzzaman, and M.Z. Hasan, RSC Adv. 15, 13643 (2025). https://doi.org/10.1039/D5RA01748C
K. Sekar, L. Marasamy, S. Mayarambakam, H. Hawashin, M. Nour, and J. Bouclé, RSC Adv. 13, 25483 (2023). https://doi.org/10.1039/D3RA04617D
A. Yadegarifard, H. Lee, H.-J. Seok, I. Kim, B.-K. Ju, H.-K. Kim, and D.-K. Lee, Nano Energy, 112, 108481 (2023). https://doi.org/10.1016/j.nanoen.2023.108481
A. Rehman, S. Afzal, I. Naeem, D. Bibi, S.G. Sarwar, F. Nabeel, and R.M. Obodo, Hybrid Adv. 7(2), 100301 (2024). https://doi.org/10.1016/j.hybadv.2024.100301
S.A.A. Jafri, R.S. Almufarij, A. Ashfaq, R.S. Alqurashi, L.G. Alharbe, A.R. Abd-Elwahed, O.A. Albeydani, et al., Sol. Energy, 270, 112391 (2024). https://doi.org/10.1016/j.solener.2023.112391
H. Al-Dmour, East Eur. J. Phys. (2), 445 (2024). https://doi.org/10.26565/2312-4334-2024-2-58
M. Abdelfatah, A. El-Sayed, W. Isamil, V. Sittinger, and A. El-Shaer, Sci. Rep. 13, 4553 (2023). https://doi.org/10.1038/s41598- 023-31553-4
M. Burgelman, P. Nollet, and S. Degrave, Thin Solid Films, 361-362, 527 (2000). https://doi.org/10.1016/S0040-6090(99)00825-1
B. Zaidi, N. Mekhaznia, M.S. Ullah, and H. Al-Dmour, J. Phys.: Conf. Ser. 2843, 012012 (2024). https://doi.org/10.1088/1742-6596/2843/1/012012
A. Das, S.D. Peu, M.A.M. Akanda, M.M. Salah, M.S. Hossain, and B.K. Das, Energies, 16, 2328 (2023). https://doi.org/10.3390/en16052328
A. Rehman, S. Afzal, I. Naeem, D. Bibi, S.G. Sarwar, F. Nabeel, and R.M. Obodo, Hybrid Adv. 7, 100301 (2024). https://doi.org/10.1016/j.hybadv.2024.100
O.J. Sandberg, A. Sundqvist, M. Nyman, and R. Österbacka, Phys. Rev. Appl. 5, 044005 (2016). https://doi.org/10.1103/PhysRevApplied.5.044005
H. Al-Dmour, and D.M. Taylor, J. Ovonic Res. 19(5), 587 (2023). https://doi.org/10.15251/JOR.2023.195.587
L. Zhao, J. Schmidt, and A. Cuevas, Appl. Phys. Lett. 101, 123904 (2012). https://doi.org/10.1063/1.4754609
H. Karmaker, A. Siddique, B.K. Das, and M.N. Islam, Results Eng. 22, 102106 (2024). https://doi.org/10.1016/j.rineng.2024.102106
G.G. Njema, B.C. Mosonik, C.C. Ahia, and J.K. Kibet, Chem. Eur. J. 30(71), e202403192 (2024). https://doi.org/10.1002/chem.202403192
H. Al-Dmour, AIMS Mater. Sci. 8(2), 261 (2021). https://doi.org/10.3934/matersci.2021017
S. Wu, C. Li, S.Y. Lien, and P. Gao, Chemistry, 6, 207 (2024). https://doi.org/10.3390/chemistry6010010
D.W. Husainat, P. Ali, J. Cofie, J. Attia, A. Fuller, and A. Darwish, AJOP, 8(1), 6 (2020). https://doi.org/10.11648/j.ajop.20200801.12
T. Rahman, A.A. Mansur, M.S.H. Lipu, et al., Energies, 16(9), 3706 (2023). https://doi.org/10.3390/en16093706
G.G. Njema, J.K. Kibet, S.M. Ngari, Measurement: Energy, 2, 100005 (2024). https://doi.org/10.1016/j.meaene.2024.100005
M.A. Madanat, A.A. Al-Tabbakh, M. Alsa'eed, H. Al-Dmour, and M.S. Mousa, Ultramicroscopy, 234, 113479 (2022). https://doi.org/10.1016/j.ultramic.2022.11347
A. Kumar, N.P. Singh, A. Sundaramoorthy, Mater. Lett. X, 12, 100092 (2021). https://doi.org/10.1016/j.mlblux.2021.100092
Downloads
Published
Issue
Section
License
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
