Soldering products in vacuum using vacuum arc discharge

Authors

  • В. А. Столбовой Национальный научный центр «Харьковский физико-технический институт»

Keywords:

vacuum-arc installation, two-stage discharge, cathodes, refractory materials

Abstract

The variants of modernization of vacuum-arc installation type «Bulat-6» for heating and soldering parts in a vacuum were considered. Techniques for silver brazing filler metals during heating product with metal ions were listed. Using Cu as the solder material is possible only at modernizing installation and using a two-stage discharge. This allowed to solder Cr, Mo, Zr, W, Ti and other refractory materials with each other without using of flux.

Author Biography

  • В. А. Столбовой, Национальный научный центр «Харьковский физико-технический институт»
    С. н. с.

Downloads

Published

2017-02-16

Issue

Vol. 1 No. 2 (2016): Журнал фізики та інженерії поверхні

Section

Статті

License

У відповідності з типовим шаблоном.

How to Cite

Soldering products in vacuum using vacuum arc discharge. (2017). Journal of Surface Physics and Engineering, 1(2), 152-157. https://periodicals.karazin.ua/pse/article/view/7908

Most read articles by the same author(s)