Justification of a High-Energy Regime for Water Disinfection by an Electron Beam
DOI:
https://doi.org/10.26565/2312-4334-2025-3-46Keywords:
Water disinfection, Electron beam, Bremsstrahlung, Induced activity, Photonuclear reactions, Computer simulation, Sub-threshold energyAbstract
The challenge of providing safe and clean drinking water requires reliable disinfection methods. Electron beam processing is a promising technology, but its industrial application is often limited by regulatory constraints, which typically cap the electron energy at 10 MeV to prevent induced radioactivity. This paper presents a theoretical justification for the radiological safety of using a higher, sub-threshold energy regime. This paper proposes operating in the 10–15.6 MeV range (using 14.9 MeV as a case study) and demonstrate that this approach allows for the treatment of significantly thicker water layers compared to the standard 10 MeV regime, while ensuring radiological safety. A comprehensive numerical model was used to simulate the process, calculating the bremsstrahlung photon spectrum and the induced activity from potential photonuclear reactions. A quantitative analysis of induced activity was performed for the main components of water (16O, 2H) and typical trace impurities according to Ukrainian standards (DSanPiN 2.2.4-171-10). The analysis proves that the induced radioactivity is negligible. The primary activation channel on oxygen is energetically forbidden, and the activity from trace elements is short-lived and falls far below the intervention levels set by Ukrainian radiation safety norms (NRBU-97). This work provides a strong physics-based rationale that a high-energy, sub-threshold regime is radiologically safe, which allows for a reconsideration of existing energy limitations in the design of electron beam water treatment facilities.
References
J.W.T. Spinks, and R.J. Woods, An Introduction to Radiation Chemistry, 3rd ed. (Wiley-Interscience, New York, 1990).
State Sanitary Norms and Rules DSanPiN 2.2.4-171-10, Hygienic requirements for drinking water intended for human consumption, (Kyiv, 2010). (in Ukrainian).
Radiation Safety Standards of Ukraine (NRBU-97), Normy radiatsiinoi bezpeky Ukrainy [Radiation Safety Standards of Ukraine], (Kyiv, 1997). (in Ukrainian).
Koning, A., Hilaire, S. Goriely, S. TALYS: modeling of nuclear reactions. Eur. Phys. J. A 59, 131 (2023). https://doi.org/10.1140/epja/s10050-023-01034-3
IAEA-TECDOC-1570, ”Radiation Treatment for Disinfection of Water and Wastewater,” (International Atomic Energy Agency, Vienna, 2008).
G. Van Rossum, and F. L. Drake, Python 3 Reference Manual (CreateSpace, Scotts Valley, CA, 2009).
C.R. Harris, et al., ”Array programming with NumPy,” Nature, 585, 357-362 (2020). https://doi.org/10.1038/s41586-020-2649-2
J.D. Hunter, ”Matplotlib: A 2D graphics environment,” Computing in Science & Engineering, 9, 90-95 (2007). https://doi.org/10.1109/MCSE.2007.55
M.J. Berger, J.S. Coursey, M.A. Zucker, and J. Chang, “ESTAR: Stopping-Power and Range Tables for Electrons,” National Institute of Standards and Technology, Gaithersburg, MD. [Online]. Available: https://www.nist.gov/pml/stopping-power-range-tables-electrons-protons-and-helium-ions
L. I. Schiff, ”Energy-Angle Distribution of Thin Target Bremsstrahlung,” Physical Review, 83, 252 (1951). https://doi.org/10.1103/PhysRev.83.252
F. H. Attix, Introduction to Radiological Physics and Radiation Dosimetry (Wiley-VCH, 2004).
K. S. Krane, Introductory Nuclear Physics (John Wiley & Sons, 1988).
Downloads
Published
Issue
Section
License
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
